Karcher Pressure Washer Seals and Gaskets

Genuine Karcher replacement part, this item is sold individually. The purpose of the 9.181-005.0 Filter Seal Hose Connector is to act as a seal to keep water from leaking out of the hose connection. It also will keep debris from entering the pump and causing it to fail.

Genuine Karcher replacement part, this item is sold individually. This O-Ring/ Seal is part of the water inlet system of the Pressure Washes shown below. Over time this type of part will deteriorate and fail. At this time you will notice a water leak and need to replace this part.

It is an OEM item which is made for Karcher pressure washers. This component provides an air-tight seal for the pump housing. Over time the material will wear out and it may begin to crack eventually requiring a replacement to prevent leaks. To ensure the correct installation of the new gasket, refer to the appropriate diagrams of your specific model. Note, it is made of a durable material and is ...

This is a genuine Karcher replacement part that has been sourced from the original manufacturer to be used with pressure washers. The o-ring is used to provide spacing between the pressure seals and valves. This item is sold as an individual replacement part.

This gasket is made of flexible rubber material and fills the space between the bush and the washer. It is used in Karcher pressure washers, and will need replacing if it breaks apart. This gasket is an OEM replacement part and is available as a single item.

This is a genuine Karcher part. The plastic, compact seal is compatible with many pressure washer machines. The seal is often fitted between the housing low pressure seal and the back ring low pressure seal. Please refer to specific manual and diagrams for repair instructions. This item is used to help prevent lubricant leakage, protect bearings and rotating shafts. The compact seal is sold indivi...

This is a genuine Karcher part sourced directly from the manufacturer for use in pressure washers. The seal goes between the washer and the bush. It seals the connection so that water does not leak out. This part is made of hard rubber and is sold individually.

This grooved ring seal is an authentic OEM replacement part used in pressure washers. It is a rubber seal with a diameter of 0.8 inches. The ring seal is found in the motor housing, where it helps to maintain the correct pressure preventing the water from leaking out of the pump housing. It also prevents water from entering the housing and causing damage. Over time the seal may wear down, tear, or...

This part is made of plastic and is sold individually. The high pressure seal fits next to the high pressure seal back ring and will require replacing if it breaks. A screwdriver might be required when replacing this part. It is an authentic OEM sourced part which is specially designed for use with Karcher pressure washers.