This is a genuine manufacturer sourced replacement part designed for use with Dewalt miter saws. This wear plate helps to minimize the friction and avoid potential wear to the table assembly. It is made out of plastic and it is sold individually.
Removed/replaced saw fence adjustable base. Four star screws held fence and single nut held base. removed and installed. Easy as that. Ereplacementparts really seems to understand that I make my living with these tools. Complete selection and RAPID shipping. Great to know. I have tossed expensive tools that I should have fixed in the past
... Read more. Never again.
Removed drive belt cover
Removed drive belt
Removed motor cover with armature
Removed armature from housing
Used bearing separator and press to remove drive pulley, then damaged bearing.
Inner race of bearing was very tight so we thinned it with a carbide burr and broke it off the shaft
Retaining screw
... Read morefor drive pulley was installed with Loctite, had to heat to soften Loctite and remove.
Only the large bearing was bad but I replaced both while apart
Reassembled in reverse order.
Helpful to have some experience
First remove the two screws from each side of fence then remove the screw from the kerf plats last there will be one bolt to remove before top and bottom separate. Once separated take out old wear plate and replace with new one and repeat steps from last to first to put saw back together and thatGÇÖs it! Very simple repair and fixed the
... Read moreissue
Removed fence, removed Kerf boards, removed pivot bolt nut, lifted saw from base, removed old wear plate, properly placed new wear plate, aligned saw back to base, lightly snugged pivot bolt nut, checked miter base rotation ( pivot bolt nut too tight base will not rotate, too loose and saw will wobble on base, cuts won\'t be accurate) rep
... Read morelace new kerf boards, reattach fence, oh and for the ones that need to be told....always unplug the saw before you work on it!!!
Removed the slot covers.
Removed the base lug nut.
Removed the material plate screws and plate.
Replaced the wear plate .
Reassembled taking care not to overtighten
the plate screws.
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
