This is an OEM sourced replacement part used on Shindaiwa trimmers. Its purpose is to filter out dust and debris from contaminating the carburetor and engine. When replacing the filter you can open the package in comes in and put a bit of two cycle oil in the bag and let it absorb into the filter. Then remove it from the bag and squeeze it with a paper towel to remove the excess oil. To replace this filter no special tools are needed. Simply remove the cover and replace the filter element.
Removed pull rope replaced it and replaced some older parts. New parts worked like a champ she sounds amazing. Basically removed bolts holding it and replaced it
Removed the shaft from the engine, air filter, plug cover and clutch shroud, fuel tank and cleaned all the parts. Replaced cracked fuel lines and pipe assy, with fuel filter and breather. Replaced clutch and spark plug. Checked air gap at mag/coil and lubed shaft end splines and greased the head.
Keeping the cooling fins clean after
... Read more each use is important to prevent overheating.
Read less
Did you find this story helpful?
Thank you for voting!
The engine was getting flooded the spark plug would be soaked with fuel .
I removed the carburetor the two screws behind the air filter and two fuel lines also tilt the carb to disconnect the throttle cable .Put the fuel lines back in same location when you reassemble.I disassembled the carb the four screws that holds the prime bulb and discovered the fuel pump diaphragm was hard and brittle. The diaphragm was
... Read moreholding the needle open causing the engine to flood. I reassembled the carburetor installing a new Gasket/ Diaphragm Kit. The trimmer runs Great !
Removed the screws form the primer cover and removed the cracked primer, and installed the new one. Screwed the primer cover down. Removed the air filter cover and removed the old filter and placed the new one in, then replaced the cover
Loosened the tension on the chain and bar
Removed the cover
Remove the chain and bar
Installed the new bar and installed the chain
Replaced the cover
Adjusted the chain and bar tension
Removed the air cleaner cover
Removed the old filter and inserted the new one
Replaced the air filter cove
... Read morer
Read less
Did you find this story helpful?
Thank you for voting!
< Prev
1
2
Next >
Model Cross Reference
This part works with the following models:
ERP Number: ERP9178369
Manufacturer Part Number: A226000740
This part is in stock in our warehouse and will ship out within 1 business day of the order being placed.
New stock is on the way! On order parts usually ship within 7 business days.
Item is not in stock and usually ships 10-15 business days from the time you place your order.
This item is no longer being made by the manufacturer, and cannot be added to your shopping cart.
✖
Mail-In Recycling Rebate
Some of the parts we sell are eligible for mail-in rebates since we can recycle them. We will display any applicable rebates in your shopping cart. To redeem your rebate, contact Customer Service after you have received your part.
