Sander Springs and Shock Absorbers

This is a genuine Makita replacement part, it is sold individually. It has a soft foam pad with a metal backing. It has six vacuum holes for use with the 166078-4 Dust bag. It is remove by unscrewing four 266020-6 Screws. The sandpaper is held by two clamps on the base assembly.

This an authentic Dynabrade replacement part used in buffers and sanders. The spring is used to absorb shock from the valve when tool is in use. It goes between the air control ring and the tip valve. A wrench may be needed to properly install this part. This item is available as an individual replacement part.

This is an authentic OEM part. The Makita compression spring 7 is made for use with several router and grinder devices. The metal spring is often fitted in the motor bracket, providing tension to the pin. This component is sold individually. Please refer to the specific manual for repair instructions. No tools should be necessary for making the installation.

This is a genuine Makita replacement part that has been sourced from the original manufacturer to be used with sanders and polishers. The rubber pad attaches to the spindle shaft and is used to support the polishing pad. This item is sold as an individual replacement part.

This is an authentic Chicago Pneumatic replacement part, sourced from the original manufacturer for use with pneumatic power tools. The metal spring is commonly used to provided compression on the throttle valve assembly. This throttle valve spring is available as an individual replacement part, please see model diagram for associative parts.