Sander Polisher Transmissions and Clutches

This brake ring is an authentic component. It is sourced directly from the original equipment manufacturer for use with Makita sanders. The brake ring fits on top of the sander pad. Over time it may wear out or get damaged eventually requiring a replacement. It is made of high-quality plastic and is sold as an individual component. Check the diagrams of your model for the exact location and the co...

Genuine Dewalt replacement part, this item is sold individually. The purpose of the 624302-00 Brake is to keep the sanding pad of the Random Orbit Sander at a slower speed so that the sander can sand the stock properly. A good time to replace the Brake is when you replace the sanding pad. Or replace it when the pad is spinning out of control at high RPM.

This brake is a genuine Ryobi replacement part. It is commonly used in random orbit sanders. It is made of rubber and sold individually. A screwdriver is needed for replacement. To replace this part: 1. Remove the backing pad by removing the four screws. 2. Remove the top cap by extracting the retaining screws. 3. Remove the switch trigger by lifting it out of the unit. 4. Remove the retaining sc...

This is a genuine Milwaukee replacement part, It is sold individually. This part controls the random orbit functions of of the Milwaukee sander it is used on. If this part breaks or gets worn, the sander will operate poorly and the pad will rotate at a high rate of speed.

This sander disc plate is an OEM direct from Craftsman for sanders. This part supports and holds the sanding disc. It is recommended that the user unplugs the sander before replacing this part. You will need a screw driver to replace this part. This sander disc plate is made of rubber and sold individually.

This genuine part is supplied by the original equipment manufacturer for use with Milwaukee power tools. The bevel gear is an important component that helps to drive the spindle. Unfortunately, over time parts may wear out or get damaged eventually requiring replacements. Keep in mind this high-quality kit includes two durable metal gears. Refer to the owner's manual and the diagrams for your mode...

This is a genuine manufacturer-approved gear lube that is specially produced for use with Cleco and Dotco sanders and grinders. It helps to lubricate the system allowing for easy movement and protecting the parts from the usual wear. Keep in mind this high-quality 2 oz. tube is sold individually. Please make sure to refer to the owners manual of your tool for the correct application.

This is an authentic Ryobi replacement part, sourced from the original manufacturer for use with orbital sanders. The rubber brake assembly fits just above the sanding pad assembly and is used to support the pad. This item is available as an individual replacement part.