Sander Polisher Legs and Feet

Genuine OEM replacement part, this item is sold individually. The purpose of the the 144988-02 Foot is to attach the platen to the sander. To replace the Foot, you will need to remove the screws from the platen. Then you will need to separate the motor housing and slide the Feet out of the housings. You will then be able to reverse the procedure and get sanding again.

It is a genuine manufacturer-sourced replacement component which is specially designed for Makita sanders. This special foot is attached to the base of the unit, please make sure to check appropriate diagrams of your model for the correct application of this hardware. It is made of durable metal material and it is sold individually.

This is a genuine Porter Cable replacement part that has been sourced from the original manufacturer to be used with belt/disc sanders. The rubber foot attaches to the bottom of the base assembly. This item is used to provide a stable footing for the machine to reduce vibration. A screwdriver may be needed to install this part. The rubber foot is priced as a single item.

This metal foot is an original Makita part made to fit the finishing sanders listed below. The foot buffers and supports between the bearing box, base, and pad. Sold individually. Often purchased and used with these parts (see manual for which parts are needed): • O Ring, part # 213983-7 or # 213045-1 • Sponge Sleeve 9, part # 424023-8 • Tapping Screw 4X12, part # 266020-6 or Flat Fillister...