Sander Polisher Knobs

This part is an OEM part from Ridgid for use on a spindle sander. The purpose of the spindle knob is to lock the sanding drum and sanding belt assembly in place. This spindle knob has left-hand threads to loosen the knob turn it clockwise and to tighten turn counter-clockwise. The knob itself is made of a durable plastic with a metal shaft. This item is sold as an individual replacement part.

Genuine OEM replacement part used on Belt Sanders. it is Sold Individually. This part consists of a Plastic Knob with a Metal Threaded Shaft. This part in conjunction with a Spring will allow you to Adjust Belt Tracking by turning the Knob in either direction until the edge of the belt is even with the outer edge of the rear rubber-covered pulley. Replacing this part is very easy and it does not ...

This is a Genuine OEM Sourced replacement part designed for use with Sanders and Band Saws. This item is made out of Plastic and it is Sold Individually. It includes Two (2) Pieces of the Knob. Please note the Screw used to secure this Knob is Sold Separately.

This is an authentic Ridgid replacement part manufactured for use with oscillating edge belt sanders. The knob is used to adjust the stop plate. This knob is sold individually, please see model diagram for additional parts.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with sanders and polishers. The plastic dial connects to the housing and is used to actuate the controller assembly when changing the tool's speed. This item is available as an individual replacement part.

This genuine manufacturer-sourced component is specially designed for use with Porter Cable power tools. It is an identical replacement for a missing or a faulty knob that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal with a plas...

This is an OEM part sourced directly from the manufacturer. The knob is designed for use in Milwaukee band files. This part is made of metal and high-quality plastic, and is used to adjust the tension arm. No tools are required when replacing this item. Simply remove the old part and screw the new one into place. This item is sold individually.