Senco Nailer Valves

This part is an OEM from the Senco manufacturer. The valve assembly is constructed of metal and plastic parts, and is compatible with several staplers and nailers. This component expels air from the device after it has discharged. This item is sold individually. An Allen wrench is needed for the removal and replacement.

This is a genuine manufacturer-sourced component which is specially designed for Senco staplers and nailers. It is an identical replacement for a missing or faulty trigger valve assembly that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality assembly is sold individually.

This is a genuine manufacturer-sourced component which is specially designed for Senco staplers. It is an identical replacement for a missing or faulty trigger valve assembly that was originally installed on a new unit. This is the part of the trigger mechanism that engages the tool. Please make sure to check the appropriate diagrams for your model for the correct location and application of this ...

This is a genuine manufacturer sourced replacement part used on Senco nailers. This assembly consists of a two (2) rubber seals, two (2) rubber washers, metal spring and a metal valve. If your tool is leaking air or gets stuck, replacing firing valve assembly may resolve the issue. To complete this repair you would need a screwdriver and pliers.

It is a genuine item that is supplied by the original equipment manufacturer for use with Senco nailers. The valve helps to ensure a tight seal inside the cylinder, unfortunately, over time it will wear out and it may begin to fail eventually requiring a replacement. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep ...

This valve assembly is supplied directly from the original equipment manufacturer. This metal and plastic component is made for use with several nailer devices. The valve assembly is located towards the back of the nail gun. This part is designed to let the air out after the trigger is pulled. A hex key is necessary for the proper installation. The valve assembly is sold individually.

This is a genuine Senco replacement part used in compatible finish nailers. The valve attaches to the main body assembly and is made of plastic and metal. A hammer may be needed during the replacement of this part. It will need to be replaced if it becomes broken. This part is available as an individual replacement.

This is an original part from Senco. The trigger valve assembly is designed for use with several finish nailers, and is sold individually. This item is part of the nailer trigger mechanism. A hex key and pliers may be necessary for the removal and replacement.