DeWALT Electric Drill Seals and Gaskets

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: • Extrusion and Nibbling - O-ring has ragged, tattered edges. These are commonly...

O-rings are commonly utilized to provide a tight seal between connected components. Unfortunately, over time the material will wear out and it may begin to crack eventually requiring a replacement. Keep in mind this high-quality o-ring is made of durable rubber material and is sold as an individual item. It is a genuine item that is supplied by the original equipment manufacturer for use with DeWA...

This is an authentic manufacturer sourced replacement part designed for use with DeWALT and Black and Decker rotary demolition hammers. It helps to provide an air-tight seal for the cap, please make sure to refer to the appropriate diagrams of your model for the correct location and use of this hardware. It is made of high-quality rubber and it is sold individually, over time the material may wear...

This is an original replacement part sourced directly from the manufacturer. The gasket is commonly found in drills from DeWALT and Black & Decker. This part is made of flexible plastic, and is used to seal the connection between the gear case cover and the gear case. You will require a screwdriver when replacing this item. The gasket is sold as an individual replacement part.

This is an original replacement part manufactured for use with rotary hammers. The special o-ring is commonly used to provide cushioning and spacing at the connection point between part assemblies. This o-ring is used with several different models of rotary hammers and the part application may vary depending on the model. The o-ring is sold as an individual replacement part, please see model diagr...

O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. Of the many causes for O-Ring failure, the most common among power tools are: • Extrusion and Nibbling - The O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off ti...

It is a genuine item that is supplied directly from the original equipment manufacturer for use with DeWALT and Black and Decker screwdrivers. This special component is utilized to provide an air-tight seal between connected parts, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind over time the material may w...