OEM Porter Cable Trimmer Parts & Accessories

Sub-base

$14.92

Manufacturer Part Number:: N381728

This part is available as an individual replacement. The sub-base is made of plastic and attaches to the base. When replacing this part a screwdriver may be needed. It will require replacing if it becomes cracked or broken. This item is an original part from DeWALT for use in laminate trimmers.

Power Cord

★★★★★

(1)

$33.91

Manufacturer Part Number:: N381704

Brush Pair

$17.63

Manufacturer Part Number:: N381708

This is an authentic DeWalt replacement part that has been sourced from the original manufacturer to be used laminate trimmers. The brushes fit into the motor housing. The brushes are used to relay electricity from the switch to the motor's armature assembly. The brushes are sold as a pair.

Ball Bearing

★★★★★

(3)

$6.58

Manufacturer Part Number:: 605040-65

This Ball Bearing is sealed on both sides. It is a genuine DeWalt replacement part and is sold individually. • Ball bearings are used to reduce friction between rotating parts.. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run smoothly. • Bearings experien...

SPRING

$6.16

Minimum Quantity of 2 required

Manufacturer Part Number:: 876676

This is available as an individual replacement part. The spring fits between the knob and the washer and is made out of metal. No tools should be required to replace this part if it becomes bent or broken. This spring is an original part from Porter Cable and DeWALT for use in trimmers.

Collet

★★★★★

(1)

$19.82

Manufacturer Part Number:: N381502

This is an authentic DeWALT replacement part, sourced directly from the manufacturer. The collet is found in a laminate trimmer, and is used to clamp the bit in place. This is a metal part, and is sold individually. To replace this part, you will need a wrench to loosen the collet nut, and then the collet should be simply to remove. You may also need a screwdriver to reach the part for replacement.

Ring

$6.16

Minimum Quantity of 2 required

Manufacturer Part Number:: N381724

Brush Cap

$6.16

Manufacturer Part Number:: N381709

BALL BEARING

★★★★★

(2)

$11.01

Manufacturer Part Number:: 874538SV

This is a genuine OEM replacement part, it is sold individually. This Ball Bearing is sealed on both sides. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. • This reduces wear on the tool and allows it to run smoothly. • Bearings experienc...

BRUSH ASSEMBLY

★★★★★

(9)

$13.28

Manufacturer Part Number:: N031636

Genuine OEM replacement part Includes 1 Carbon Brush in metal housing for easy installation. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor • New brushes can restore a motor's electric braking Carbon motor brushes are one of the most commonly replaced power tool components. • Because carbon brushes are wear items, meaning...