Craftsman Tiller Springs and Shock Absorbers

This part is an OEM from MTD for use with Snowblowers. The most common reason for replacing the throttle spring is when it is damaged during another repair. This part is sold individually. Here is a list of tools that are needed to replace the throttle linkage spring needle nose pliers, 3/8 inch socket, 1/2 inch socket, 3/4 inch socket, 10 mm socket, Phillips-head screwdriver and a 5/16 inch wrench.

This OEM supplied component is designed for use with Craftsman tillers. It is the spring that connects to the governor control rod. This is an identical replacement for a missing or a faulty hardware that was installed on a new unit. The purpose of this spring is to apply tension on the #8353J Fork . Check the ...

This authentic item is supplied directly from the original equipment manufacturer for use with MTD and Troy-Bilt lawn and garden equipment. It is an identical replacement for a missing or faulty spring that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-qualit...

This is an authentic replacement part that has been sourced from the original manufacturer to be used with trimmers from Ryobi, MTD, Troy-Bilt, Yard-Man, and Bolens. The recoil spring is part of the starter assembly and is used to wind the rope back around the pulley after it has been pulled. This spring is priced as a single item.

It is an authentic manufacturer-supplied part that is specially made for use with lawn and garden equipment. This is an identical replacement for a missing or a faulty clutch spring that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality clutch spring is made of d...

The torsion spring attaches to the throttle control. It is a genuine item that is supplied by the original equipment manufacturer for use with MTD and Troy-Bilt cultivators. This part is made of metal and is available individually. During replacement, it may require a set of pliers to help install this part correctly. It will require replacing if it becomes bent or broken.

This is a genuine Briggs & Stratton and Toro part sourced directly from the manufacturer for use in engines, generators, and blower-vacuums. The pump diaphragm spring attaches to the spring cap and is made of metal. Keep in mind this high-quality part is sold individually. When replacing this part a screwdriver, wrench set, and a nutdriver may all be needed. Over time this part may bend or break a...