Troy-Bilt Edger Parts
We sell only genuine OEM Troy-Bilt ® parts.
Top Troy-Bilt Edger Models
See All ModelsPopular Troy-Bilt Edger Parts
- Manufacturer Part Number:
- 954-04032B
This genuine drive belt is an original replacement part sourced directly from the manufacturer and is commonly used in Craftsman lawn mowers and edgers. Made from flexible rubber, it transfers power from the engine to the pulley that drives the cutting blades. Over time, the belt may become brittle or cracked due to wear and exposure, requiring replacement to maintain optimal performance. Measurin...
- Manufacturer Part Number:
- 720-04072A
- Manufacturer Part Number:
- 941-0155
This authentic OEM sourced replacement part is designed for MTD lawn and garden equipment. Ball bearings are generally utilized to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. Unfortunately, over time components will wear out and may begin to fail eventually requiring...
- Manufacturer Part Number:
- 753-05251
This is a genuine OEM sourced replacement part used on gas trimmers/edgers. The purpose of this part is to mix air and gas before the fuel mix goes to the engine. If the engine won't start and the tank is full of fresh fuel, test the carburetor by removing the air filter and pouring about a teaspoon of fuel into the carburetor. Pull the starter rope. If the engine starts and then quickly dies, th...
- Manufacturer Part Number:
- 753-05259
It is an authentic item that is supplied directly from original equipment manufacturer for use with MTD and Troy-Bilt string trimmer, edgers and backpack blowers. These replacement pads are used to secure the fuel tank. It is made of durable rubber material and it is sold individually.
- Manufacturer Part Number:
- 712-0266A
- Manufacturer Part Number:
- 781-0080-0637
This edger blade is an OEM part direct from Craftsman for edgers. This part connects to the drive shaft to edge and cut grass. It is recommended to review your models diagram to verify the parts compatibility. You will need a wrench to replace this part. This edger blade is made of metal and sold individually.
- Manufacturer Part Number:
- 753-06240
This genuine replacement fuel tank assembly is soured directly from original equipment manufacturer. It is used on handheld gas string trimmers. It is made out of plastic and it includes the fuel tank, fuel lines and a fuel cap. It is very important to replace the fuel tank if it is cracked or damaged to avoid damage or serious injuries. Make sure to drain the gas tank before starting a repair. Pl...
- Manufacturer Part Number:
- BS-799579
The pre filter is a genuine replacement part for lawn mowers made by Troy-Bilt, MTD, Yard Machines, and Bolens. A wrench set may be needed during the replacement of this part. It is made out of foam and will need to be replaced if it gets dirty. This item is sold individually and helps to clean the air that enters the carburetor.
- Manufacturer Part Number:
- 794-00082
- Manufacturer Part Number:
- 747-04110A
This is a Manufacturer Approved replacement part designed for Trimmers/Edgers. This blade adjustment rod is made out of Metal and it is Sold Individually. Blade adjustment rod lets you adjust the position of the blade for bevel cutting. When replacing this Rod you will need Pliers, Socket set, Wrench Set.
- Manufacturer Part Number:
- 781-0748-0637
This is a genuine replacement part sourced directly from the manufacturer. The blade is found on Craftsman edgers. This part is made of metal, and is used to cut through turf to create a clean edge for lawns and flower beds. You will require a wrench when replacing this part. This item is sold individually.