Grill Elements and Burners

OEM Rolled Stainless Steel Emitter is sold individually. This is the emitter tray only designed to be paired with a cast iron cooking grate part 80021355. Dimensions are approx. 18-1/4 X 8-7/8" Part is 5/8" Thick. If the part is heavily rusted or damaged it needs to be replaced.

This stainless steel infrared emitter plate is designed for Char-Broil Tru-Infrared gas grills, providing even heat distribution and protecting food from direct flames for consistent cooking results. As part of the Tru-Infrared system, it converts heat from the burners into infrared energy, ensuring flavorful, evenly cooked meals. Ideal for replacing worn or damaged plates, this OEM component rest...

This is an original Char-Broil replacement part manufactured for use with outdoor grills. The burner is used to disperse flames evenly across the firebox. Over time the burner tubes can corrode and replacing damaged burners can extend the life of the grill. The main burners are sold individually.

This is a genuine replacement burner used with the Perfectflow 2-Burner Propane Stove. This part is screwed hand-tight onto the manifold. The fuel passes from the manifold into the body of the burner, escaping from the perforations circling the edge where it is lit. This is a one-piece part that is sold individually.

This stainless steel infrared emitter grate is designed for Char-Broil 3-burner Tru-Infrared gas grills, providing even heat distribution and reducing flare-ups for consistent grilling results. Positioned beneath the main cooking grates, it absorbs heat and radiates it upward while vaporizing drippings to enhance flavor and prevent flare-ups. Each grate measures approximately 17-1/8" x 8-1/8", and...

This is a genuine Char-Broil replacement part. it is sold individually. The burners are the part of the grill that the flame rises from. This burner is equipt with spider guards. The Burners flame is controlled by the control knobs that are attached to the Valve/Manifold/Regulator. It is a good idea to keep these clean and covered as they have a tendency to rust and corrode. Includes wire mesh spider guards.

This burner brace is a replacement support component designed to stabilize and position a burner assembly securely. It helps maintain proper alignment and is commonly replaced when bent, warped, or damaged by heat or wear.